Guralp Systems CMG-SAM - Manual (Page 14)

Operator’s Guide CMG SAM & CMG CRM
PORT CONNECTION CROSS REFERENCE TABLES
FUNCTION CONNECTOR
NAME
SCREAM
CONFIGURATION
SETUP BAUD
RATES
TERMINAL
WINDOW SETUP
SAM
DIGITAL OUTPUT
AUX A PORT 0
SENSOR A
DIGITAL INPUT
PORT A B PORT 1
SENSOR B
DIGITAL INPUT
PORT B C PORT 2
SAM POWER
SUPPLY
POWER - -
Currently the Aux port that is displayed in the SCREAM window in 10)
above, is not available to the user. It is an internal facility only.
NOTE
New Flash Memory SAM
FUNCTION CONNECTOR
NAME
SCREAM
CONFIGURATION
SETUP BAUD
RATES
TERMINAL
WINDOW SETUP
SAM OUTPUT &
POWER SUPPLY
DATA OUT A PORT 0
SENSOR A
INPUT
DATA IN
PORT A
B PORT 1
SENSOR B
INPUT
DATA IN
PORT B
C PORT 2
GPS GPS - -
NOTE When setting the baud rates, the user will need to consider the input rates
of the input channels compared to the output channel, and the
transmission rate of the of their data link from the SAM or CRM, that
they are compatible with each other and are able to sustain the rate of
transmission required.
13) When the user is satisfied that the selected baud rates are correct, click on the
System ID tab and change the Sam identification, if required, by clicking in the
relevant box, deleting and writing in a new ID. The System Identifier is
restricted to six alpha-numeric digits and the Serial Number is restricted to four
alpha-numeric digits.
14) Click on the Download button. The Configuration Setup window will
disappear as the SAM reboots and the new SAM ID will appear in the main
Start-up Window.
Issue D March 2001 12