Guralp Systems CMG-SAM User Manual
Page 27
Operator’s Guide CMG SAM & CMG CRM
Use only if SET-CLOCK command is not recognised.
Usage:
HEX yyyy mm dd hh mm ss 0 SET-RTC
n MB-FILE
Sets the amount of silicon file to use for transfers to the
disk, 'n' in Megabytes
Y
RECYCLE
Sets the disk mode to overwrite the oldest data (circular
store)
N
USE-ONCE
Sets the disk mode to non-circular mode (stops
recording when the disk is full)
N
RESET-DISK or
RESET-DISC
Resets the SCSI and marks as blank. The contents will
be wiped from the disk on next write.
N
DIR
Lists the contents of the disk, including start and end
dates and times.
N
FLUSH
Forces the contents of the Silicon File to be transferred
to disk. Useful to clear out memory prior to disk
removal or unit power-down
N
OPEN i s
Open a pass-thru link to the instrument with System ID
'i' and serial number 's'.
N
STREAMS?
Lists all streams detected by the SAM, displaying the
serial number (and tap information), System ID, and
port the stream is received on. Normally used in
conjunction with OPEN command.
N
GO or
CLOSE
Leave command mode and resume transmission of data
blocks
N
* Some commands require a re-boot of the SAM in order for the changes to take effect.
Note that if several settings are changed, it is not necessary to re-boot after each change
– only one re-boot is necessary after all required changes have been made.
Issue D March 2001
25