Harken 7311.10 Cruising Jib Reefing & Furling - Manual (Page 12)

12 Unit 1, 2 Cruising 08/23/10
Preassembly Foil Length
Line up bottom foil so clamp screw holes
are lined up with third row of holes as
shown.
Note: Mark top foil so foil with trim cap will
ride 1/2" (12 mm) below terminal. If wire
fitting at top of stay is swage, foil must ride
just below shoulder of swage. Mark cut line
on foil. Wrap tape around foil as a guide
so cut is straight. Check length to see
if it matches results from chart on
page 9 (Unit 1) or page 10 (Unit 2).
Confirm foil length by laying foils alongside
stay with turnbuckle components.
Pull stay out so it is straight. Attach Harken
toggle to bottom of stay. Adjust turnbuckle
so that length of stay with Harken toggle
will fit boat. Ideally, turnbuckle will be
half to two-thirds open to allow for rig
adjustment.
Line up drum assembly so holes below
drum line up with holes in Harken toggle.
Make sure toggle is tensioned when
measuring.