Rod rigging – Harken 7311.10 Cruising Jib Reefing & Furling User Manual
Page 16
Advertising
Insert two cotter pins and
spread. Clean excess Loctite
®
from terminal body using
special care to ensure that
there is no red Loctite
®
on threaded stud.
Assembly
Rod Rigging: Rod Adapter Stud
Apply a few drops of red
Loctite
®
to threads of
nosepiece.
Screw main threaded stud
portion onto bronze nosepiece
until flats align with two cotter
pin holes in terminal body.
Tip: Turn nosepiece
completely into threaded
stud portion. Flats will be
close and may only require
a small half turn to align
with cotter pin holes.
ROD RIGGING
16
Unit 1, 2 Cruising
5/30/08
Advertising
This manual is related to the following products: