Hypertherm PCBS-0124 - Manual (Page 49)

Award BIOS Setup
45
Swap Floppy Drive:
If the system has two floppy drives, you can swap the logical drive name
assignments.
The choice: Enabled, Disabled.
Boot Up Floppy Seek:
Seeks disk drives during boot up. Disabling speeds boot up.
The choice: Enabled, Disabled.
Report No FDD For Win 95:
Whether report no FDD for Win 95 or not.
The choice: Yes, No.
Boot Up NumLock Status:
Select power on state for NumLock.
The choice: Off, On
Gate A20 Option:
Select if chipset or keyboard controller should control GateA20.
Normal---A pin in the keyboard controller controls GateA20
Fast---Lets chipset control GateA20
Typematic Rate Setting:
Keystrokes repeat at a rate determined by the keyboard controller. When
enabled, the typematic rate and typematic delay can be selected.
The choice: Enabled/Disabled.
Typematic Rate (Chars/Sec):
Sets the number of times a second to repeat a keystroke when you hold the
key down.
The choice: 6, 8, 10, 12, 15, 20, 24 and 30.
Typematic Delay (Msec):
Sets the delay time after the key is held down before it begins to repeat the
keystroke.
The choice: 250, 500, 750 and 1000.