Hypertherm PCBS-0124 - Manual (Page 61)

Award BIOS Setup
57
Suspend Mode:
When “Enabled” and after the set time of system inactivity. All devices
except the CPU will be shut off.
The choice: Enabled, Disabled.
HDD Power Down:
When “Enabled” and after the set time of system inactivity, the hard disk
drive will be powered down while all other devices remain active.
The choice: Enabled, Disabled.
Soft-Off by PWR-BTTN:
Pressing the power button for more than 4 seconds forces the system to
enter the Soft-Off state when the system has “hung.”
The choice: Delay 4 Sec, Instant-Off.
CPU THER-Throttling:
Select the CPU THRM-Throttling rate.
The choice: 12.5%, 25.0%, 37.5%, 50.0%, 62.5%, 75.0% and 87.5%.
Wake-Up by PCI Card:
An input signal from PME on the PCI card awakens the system from a soft off
state.
The choice: Enabled, Disabled.
Power On by Ring or WOL:
An input signal on the serial Ring Indicator (RI) line (in other words, an
incoming call on the modem) awakens the system from a soft off state.
The choice: Enabled, Disabled.
Resume by Alarm:
When “Enabled”, your can set the date and time at which the RTC (real-time
clock) alarm awakens the system from Suspend mode.
The choice: Enabled, Disabled.