Hypertherm LR2075 - Manual (Page 55)

a-4 Hypertherm Laser Heads
Ophir Optronics Ltd.
Science Based Industries Park Har-Hotzvim
P.O.Box 45021 Jerusalem 91450, ISRAEL
Tel: 972-2-5484444 Fax: 972-2-5822338
w w w . o p h i r o p t . c o m
[email protected]
If material is to be machined, ground or polished, processes should be
done wet so as to minimize dust, which could result in inhalation. Good
work practices such as keeping hands clean and not letting slurry splash
significantly should be followed so that transferal to mouth by
contamination on the hands or clothing followed by ingestion will not occur.
Wash hands and face thoroughly after handling material and before eating.
If parts are dropped or otherwise broken, sweep up pieces which may have
sharp edges as one would clean up broken glass and safely transfer to
appropriate disposal container.
Section VI – Reactivity Data
• Stability: Stable
• Conditions to avoid: Extreme heat greater than 500 Celsius could result in
decomposition.
• Materials to avoid: Strong acids, strong bases.
• Hazardous decomposition products: Selenium/Oxides of Selenium, Zinc Oxide
• Hazardous polymerization: Will not occur.
Section VII – Disposal Information
Dispose of used laser optics in a licensed industrial waste facility in compliance
with all local, state, and federal regulations. If you do not have access to a licensed
industrial waste facility, the used laser optics may be returned to Ophir Optics, Inc
for disposal. Contact Ophir Optics, Inc before returning any used optics.
Section VIII – Special Protection Information
Respiratory Protection: (In dust or vapor form)
NIOSH approved respiratory with fume type cartridge
Ventilation:
___Local Exhaust
___Mechanical (General)
___Special (Specify)
X Other (Specify) See Below
In case of vaporization: