ifm electronic JN2301 - Manual (Page 5)

UK
Inclination sensor JN
5
The connection terminals may only be supplied with the signals indicated in the
technical data and/or on the device label and only the approved accessories from
ifm may be connected�
2.4 Tampering with the device
Contact the manufacturer in case of malfunction of the unit or uncertainties�
Any tampering with the device can seriously affect the safety of operators and
machinery� In case of tampering with and/or modifying the unit, any liability and
warranty is excluded�
3 Functions and features
The 2-axis inclination sensor with SAE J1939 interface enables angle levelling and
position detection of mobile machines�
Typical applications are, for example, the position detection of access platforms,
levelling of mobile cranes or set-up of mobile machines�
Properties:
● 2-axis inclination sensors with a measuring range of ±45°
● High accuracy and resolution
● High sampling rate and band width
● Diagnostic Trouble Code (DTC) available
● Configurable limit frequency (digital filter) for vibration suppression
● Programming key
4 Installation
4.1 Fixing
► Fasten the device using 4 M5 screws on a flat surface�
Screw material: steel or stainless steel�
4.2 Mounting surface
The housing must not be exposed to any torsional forces or mechanical
stress�
► Use compensating elements if there is no flat mounting surface available�