Ivoclar Vivadent IPS e.max Abutment Solutions Cem Kit - Manual (Page 14)

14
Additional notes
– Multilink Hybrid Abutment should be processed at
room temperature. Low(er) temperatures may cause
difficulty in dispensing and mixing the material and
may prolong the working and curing time.
– Unpolymerized material may stain clothing.
Warning
– Contact of uncured Multilink Hybrid Abutment with
skin/mucous membrane and eyes must be prevent-
ed. In an unpolymerized state, Multilink Hybrid
Abutment my cause slight irritation and lead to a
sensitization against methacrylates. Commercial
medical gloves do not provide protection against the
sensitizing effect of methacrylates.
– Monobond Plus:
– Highly flammable
– Irritating
– The product contains ethanol.
– The product must be kept away from sources of
ignition.
– Virtual Extra Light Body Fast Set:
If uncured material comes in contact with the eyes,
they should immediately be rinsed with plenty of
water. If irritation persists, a physician should be
consulted. If the material comes in contact with the
skin, it should be rinsed off with water and soap.
Shelf life and storage
– The individual components of the IPS e.max
Abutment Solution Cem Kit should not be used after
the indicated date of expiration.
– Shelf life: see note on syringes/bottles/cartridges
– Storage temperature of Multilink Hybrid Abutment,
Monobond Plus, Liquid Strip and Virtual Extra Light
Body Fast Set: 2–28 °C/36–82 °F.
– Monobond Plus and Liquid Strip: Close immediately
after use.
– Multilink Hybrid Abutment and Virtual Extra Light
Body Fast Set:
The mixing tip is left on the syringe/cartridge after
use. The material contained within will polymerize
and allow the mixing tip to function as a seal.
Keep out of the reach of children!
For use in dentistry only.
The material has been developed solely for use in dentistry. Processing
should be carried out strictly according to the Instructions for Use. Liability
cannot be accepted for damages resulting from failure to observe the
Instructions or the stipulated area of application. The user is responsible for
testing the material for its suitability and use for any purpose not explicitly
stated in the Instructions. Descriptions and data constitute no warranty of
attributes and are not binding.
emax AbutSol_Cem_GI_WE1_649681_REV1.indd 14 10.10.13 15:40