Ivoclar Vivadent IPS e.max Abutment Solutions Cem Kit - Manual (Page 7)

7
Hybrid abutment crown
The following procedure should be observed during the clinical try-in:
– The prepared and cleaned hybrid abutment crown (provisionally secured in place with Virtual Extra Light Body
Fast Set) is laid out.
– The provisional restoration is removed.
– The hybrid abutment crown is placed on the implant intraorally in order to check and if necessary adjust the
proximal contacts. Note: No occlusal functional inspection must be performed at this stage.
– The hybrid abutment crown is screwed in manually with the dedicated screw.
– The geometry of the hybrid abutment crown is checked (e.g. fit, gingival anaemia) in relation to the gingiva.
– The occlusion/articulation is checked and if necessary adjustments are made with suitable grinding instru-
ments (see separate IPS e.max recommended grinding instruments for ceramics – use in the dental practice).
If adjustments have been made by grinding, the restoration has to be re-polished or glaze fired again.
– The crown is carefully removed from the hybrid abutment crown (including the base).
– The implant site is rinsed, e.g. with Cervitec
® Liquid (antibacterial mouth rinse containing chlorhexidine) to
clean and disinfect it.
– The temporary restoration is placed.
The occlusion/articulation is checked and if necessary adjusted with suitable
grinding instruments.
The hybrid abutment crown is screwed in with the dedicated screw.
The hybrid abutment crown is placed on the implant intraorally in order to
check and if necessary adjust the proximal contacts. Note: No occlusal
functional inspection must be performed at this stage.
The hybrid abutment crown (including base) is carefully removed.
The geometry of the hybrid abutment crown (e.g. fit, gingival anaemia) is
checked in relation to the gingiva.
emax AbutSol_Cem_GI_WE1_649681_REV1.indd 7 10.10.13 15:39