Ivoclar Vivadent IPS e.max Abutment Solutions Cem Kit - Manual (Page 3)

3
Abutment Solutions
Provisional securing of the ceramic structure on the base
Before the ceramic structure is permanently luted to the base, a clinical try-in can take place. To facilitate intraoral
handling, the components are temporarily attached to one other with silicone material, e.g. Virtual Extra Light
Body Fast Set.
The following procedure should be observed in the temporary attachment of the components:
– The untreated base and the ceramic structure are cleaned with steam and subsequently dried with blown air.
– The ceramic structure is placed on the base (which is screwed on the model analog) and the relative position
of the components is marked with a waterproof pen. This step makes it easier to attain the correct position
when the parts are temporarily assembled.
– The screw channel is sealed with a foam pellet.
– The Virtual cartridge is inserted in the dispenser and the protective cap is removed.
– The mixing tip is screwed on and the Oral Tip is attached to the mixing tip.
– Virtual Extra Light Body Fast Set is applied to the base and directly into the ceramic structure.
– The base is introduced into the ceramic structure. The alignment of the two components must be checked
(rotation lock/marking).
– The components should be held firmly in the correct position for 2:30 minutes until Virtual Extra Light Body
Fast Set has set.
– Any excess that has been displaced must be carefully removed with a suitable instrument, e.g. a scalpel.
Cleaned, untreated ceramic structures
The screw channel is sealed with a foam pellet.
The ceramic structure is placed on the base and the relative position is
marked.
The Virtual cartridge is inserted in the dispenser. The mixing tip is screwed on
and the Oral Tip is attached.
English Optional: Clinical Try-in
emax AbutSol_Cem_GI_WE1_649681_REV1.indd 3 10.10.13 15:39