Ivoclar Vivadent Vectris - Manual (Page 53)

53
3-
UNIT
INLA
Y -
RET
AINED
BRIDGES
Sealing the dies
After having removed the matrix and cleaned the duplicate
model, apply Vectris Model Separator in two coats. Apply
the first layer slightly more generously than the second one
and make sure to fully cover all areas of the die. Watch out
for sharp edges in particular. Allow the first layer to react
for 3 minutes. Subsequently, apply the second layer of
Vectris Model Separator in a thin coating, invert the model
and allow it to dry for another 3 minutes.
Apply a generous coat of Vectris Model Separator and allow it to dry for approx. 3 minutes.
Apply the second layer of Vectris Model Separator in a thin coating and allow it to dry for
another 3 minutes upside down.