Kemppi SF 52W - Manual (Page 18)

FastMig SF 52W, SF 53W
16
EN
Restore Factory
Settings
FAC OFF, PAn, ALL OFF Control panel reset function.
OFF = No reset
PAn = Settings will be restored, but
memory channels remain unchanged
ALL = All settings will be restored to
factory values.
Setup-parameters for MMA welding
Name of parameter
Name on
display
Parameter
values
Factory
setting
Description
Start Power StA -9 ... +9 0 Strength of start pulse
Device Address Add 3 or 6 3 Wire feeder bus address
Code Entry Cod ---, Ent ---
Entering license codes manually:
1. Adjust right potentiometer to (‘Ent’).
2. Press REMOTE.
3. Set code with right potentiometer.
4. Choose next with left potentiometer.
5. Go back to point 3, until all codes have
been set.
6. Approve by pressing REMOTE. (‘Suc cEs’)
Restore Factory
Settings
FAC OFF, PAn, ALL OFF
Control panel reset function.
OFF = No reset
PAn = Settings will be restored, but
memory channels remain unchanged
ALL = All settings will be restored to
factory values
NOTE! In these setup lists following functions needs activation (Err 171):
• Arc Voltage Display
• Minilog
• Panel Locking
• WisePenetration
• WiseFusion