Kemppi MXP 37 Pipe Stee - Manual (Page 10)

EN
2.7 Loading the filler wire and automatic feed
Automatic wire feed makes wire spool changes faster. When changing the wire spool, the
pressure of feed rolls need not be released.
Simply ensure that the groove of the feed roll matches the diameter of filler wire used. Release
the wire end from the spool and cut off any deformed section. Be careful that the wire does
not spill from the spool sides.
Straighten about 20 cm of filler wire and ensure the tip has no sharp edges. File if necessary, as
a sharp wire edge may damage the wire gun liner - particularly softer plastic liners.
Present the filler wire tip to the back of the wire feed rolls and press the wire inch switch on
the wire feeder panel. Feed the wire to the gun contact tip and prepare to weld.
NOTE! Smaller diameter filler wires may need to be loaded manually and with the feed roll pressure
arms released. This is because it is easy to over estimate the pressure required to feed these smaller
filler wires. Too high feed roll pressures can easily deform filler wires and contribute to later feeding
problems.
2.8 GT04 wire feed mechanism in MXP 37 Pipe
Wire guide tubes
ø mm outlet tube middle tube inlet tube
Al, Ss (Fe, Mc, Fc)
plastic
0.6 W007285 W007273 W007293
0.8 – 0.9 W007286 W007274 W007294
1.0 W007287 W007275 W007295
1.2 W007288 W007276 W007296
1.4 W007289 W007277 W007297
1.6 W007290 W007278 W007298
2.0 W007291 W007279 W007299
2.4 W007292 W007280 W007300
Fe, Mc, Fc
metal
0.8 – 0.9 W007454 W007536
1.0 W007455 W007537
1.2 W007456 W007538
1.4 – 1.6 W007458 W007539
2.0 W007459 W007540
2.4 W007460 W007541
FastMig MXP 37 Pipe, MXP 38
8