Kemppi MXP 37 Pipe Stee - Manual (Page 5)

EN
1. INTRODUCTION
1.1 General
Congratulations on choosing the FastMig MXP welding equipment. Used correctly, Kemppi
products can significantly increase the productivity of your welding, and provide years of
economical service.
This operating manual contains important information on the use, maintenance and safety of
your Kemppi product. The technical specifications of the equipment can be found at the end
of the manual.
Please read the operating manual and the safety instructions booklet carefully before using
the equipment for the first time. For your own safety and that of your working environment,
pay particular attention to the safety instructions in the manual.
For more information on Kemppi products, contact Kemppi Oy, consult an authorised Kemppi
dealer, or visit the Kemppi web site at www.kemppi.com.
The specifications presented in this manual are subject to change without prior notice.
Important notes
Items in the manual that require particular attention in order to minimise damage and
personal harm are indicated with the ’ NOTE! ’ notation. Read these sections carefully and follow
their instructions.
1.2 About FastMig MXP 37 Pipe and MXP 38
Kemppi FastMig MXP 37 Pipe is a wire feeder designed for demanding professional use. It
is equipped with the WiseRoot+™ welding process, developed especially for efficient root
welding on pipes and plates.
Kemppi FastMig MXP 38 is a wire feeder designed for demanding professional use. It is
equipped with the WiseThin+™ welding process, developed especially for efficient welding for
thin sheets and position welding, also with CO
2
shielding gas.
FastMig MXP 37 Pipe and MXP 38 wire feeders can be used with FastMig X 450 and FastMig
Pulse power sources. However, WiseRoot+™ and WiseThin+™ special welding processes are
only available when used with FastMig X 450 power source.
Operation of the wire feeder is controlled and adjusted by microprocessor. By adding
an optional synchronization unit (MXF Sync 65), SuperSnake sub-feeder device may be
connected to MXP 37 Pipe or MXP 38 wire feeders.
Disclaimer
While every effort has been made to ensure that the information contained in this guide
is accurate and complete, no liability can be accepted for any errors or omissions. Kemppi
reserves the right to change the specification of the product described at any time without
prior notice. Do not copy, record, reproduce or transmit the contents of this guide without
prior permission from Kemppi.
3
© Kemppi Oy / 1515