Kemppi MXP 37 Pipe Stee - Manual (Page 18)

EN
3.3 Button functions
3.3.1 ON/OFF button (1)
XF 37
W007241
CH REMOTE
CHANNEL
PANEL
4T
2T
Short press: XF 37 / X 38 panel returns to initial display.
Long press: XF 37 / X 38 panel is turned ON or OFF.
NOTE! When wire feeder XF 37 / XF 38 control panel is turned ON, also the power source control
panel X 37 turns on and links automatically to this wire feeder.
3.3.2 Dynamics button (2)
XF 37
W007241
CH REMOTE
CHANNEL
PANEL
4T
2T
Short press: Dynamics setting for 1-MIG, synergic MIG and CC/CV. ArcForce setting for MMA.
Long press: Wire feeder number selection. If there is more than one wire feeder connected to
the system, you can select which of them is active. Each wire feeder has its own number (1–3).
NOTE! Wire feeder number is not available in MMA, CC and CV processes.
3.3.3 Gas test button (3)
XF 37
W007241
CH REMOTE
CHANNEL
PANEL
4T
2T
This button displays the gas test time. You can change it with the control knob.
Gas test starts when the time adjustment is made, after a short delay.
You can stop gas test by pressing any button.
3.3.4 Wire inch button (3)
XF 37
W007241
CH REMOTE
CHANNEL
PANEL
4T
2T
This button starts feeding the wire with the default speed of 5.0 m/min. The wire feed stops
when you release the button.
You can change the wire feed speed with the control knob. The changed speed is used if you
press the button again.
3.3.5 Channel down button (5)
XF 37
W007241
CH REMOTE
CHANNEL
PANEL
4T
2T WISEROOT +
/
This button selects the previous memory channel that can be found.
3.3.6 Channel up button (6)
XF 37
W007241
CH REMOTE
CHANNEL
PANEL
4T
2T WISEROOT +
/
Short press: Selects the next memory channel that can be found.
Long press: Locks or unlocs the selected memory channel. No parameter changes are allowed
to a locked memory channel.
FastMig MXP 37 Pipe, MXP 38
16