Kemppi Promig 100 - Manual (Page 15)

Promig 100/0450 – 15 ©
COPYRIGHT KEMPPI OY
Local controls
potentiometer
SELECTO OFF: Local control for wire feed speed 0...18 m/min or 0...25 m/min
SELECTO ON: Channel selection
SELECTO SET: Local control for wire feed speed 0...18 m/min or 0...25 m/min
MMA welding: Welding current control, 10 A ... max. current of power source
U-potentiometer
SELECTO OFF: Local control for voltage of Pro power source, 10 V ... max. MIG voltage
of power source
SELECTO ON: Fine adjustment for arc length
SELECTO SET: Local control for voltage of Pro power source, 10 V ... max. MIG voltage
of power source
MMA welding: No operation
Local control: Control potentiometers R1 and R2 on panel are used
Remote control: Adjustments are carried out from remote control unit R20
which is connected to remote control connector X4 of subfeeder. If you use
the remote control unit R10, adjust wire feed speed/welding power or MMA
welding current with potentiometer of the R10 and voltage/arc length with
potentiometer U on panel.
Gun control: Wire feed speed/welding power is adjusted with control module
RMT which is connected to Kemppi PMT welding gun and welding voltage/arc
length is adjusted with potentiometer U on panel.
Local controls
potentiometer
MIG/MAG: Local control for wire feed speed 0...18 m/min 0... 25 m/min
SYNERGIC MIG: Power control, min. and max. powers according to filler wires
SYNERGIC PULSED MIG: Power control, min. and max.powers according to filler wires
MMA welding: Welding current control, 10 A ... max. current of power source
U-potentiometer
MIG/MAG: local control for voltage of Pro power source, 10 V... max.
MIG voltage of power source
SYNERGIC MIG: Fine control for arc length -9...0...9
SYNERGIG PULSED MIG: Fine control for arc length -9...0...9
MMA welding: No operation
3.3. THE PROMIG 501, 501L AND 530 HAS THE ML CONTROL PANEL
Control mode selecting switch