Kemppi Promig 100 - Manual (Page 17)

Promig 100/0450 – 17 ©
COPYRIGHT KEMPPI OY
5. SERVICE, OPERATION DISTURBANCES
The amount of use and the working environment should be taken into consideration when
planning the frequency of maintenance of Promig.
Careful use and preventive maintenance will help to ensure trouble-free operation.
The following maintenance operations should be carried out at least every six months:
Check:
- The wear of the grooves of the feed rolls. Excessive wear of
grooves causes problems in wire feed.
- The wear of the wire guide tubes of wire feed. Badly worn feed
rolls and wire guide tubes should be discarded.
- The wire guide tube in the gun connector should be set as near
the feed rolls as possible, but not touching them and the wire must
follow a straight line from the end of the tube to the groove of
the feed roll.
- Reel brake adjustment
- Electric connections
* oxidized couplings must be cleaned
* loose couplings must be tightened
Clean dust and dirt from the equipment.
When using compressed air, always protect your eyes with proper eye protection.
In case of problems contact the Kemppi works in Lahti, Finland or your Kemppi dealer.
twice a
year
6. ORDERING NUMBERS
Promig 100 6236305
Promig 501 6231501
Promig 501L 6232505
Promig 530 6232530
Prosync 50 6263121
Pro 3200 6131320
Pro 4200 6131420
Pro 5200 6131520
Procool 10 6262012
Procool 30 6262016
P40 6185264
P30W 6185409
RMT10 6185475
R10 6185409
R20 6185419
5 /0,95 m 4269340
8 /1,5 m 4269030
16d/10 m 6185481
20 /5 m - 50 mm 2 6184511
20 /5m - 70 mm 2 6184711
21 /5 m - 50 mm 2 6184501
21 /5m - 70 mm 2 6184701
Hub for wire reel 4289880