Kreg KJMICRODGB Micro-Pocket Drill Guide - Manual (Page 2)

11-2009 NK7811B
KREG TOOL COMPANY
Huxley, Iowa • Customer Service 800.447.8638
Visit www.kregtool.com today for additional tools, accessories, plans, and instructional videos.
Setting the Jig
Lines molded into the side of the Drill Guide are labeled with fractional
designations that represent the thickness of the material that is being drilled.
If you are drilling a pocket hole in 3/4” material, align the 3/4” marking to the
top of the base opening, and lock it in place using the thumb screw.
To accurately set your depth collar, use the built in depth gauge and instruction
manual included with your Kreg Jig ® or Kreg Jig ® Master System.
Using the Drill Guide Separately
There are times when it is not convenient to use your Kreg Jig’s
base and it’s awkward to clamp the Drill Guide in position. For these
occasions, the Micro-Pocket ™ Drill Guide has been specially designed
to accept two SML head style screws to hold the Drill Guide in position
while drilling the Pocket-Hole.
(CauTIon: You must use the center drill guide hole “B” when drilling.)
B
Standard Pocket-Holes are created with a 3/8” diameter bit,
resulting in a finished Pocket-Hole which is 1-9/16” in length.
The Micro-Pocket Drill Guide and Micro Pocket Drill Bit help you
create a hole which is roughly 25% smaller, allowing you to work
with smaller stock and more easily conceal individual Pocket-
Holes from view. Due to the smaller size only Kreg Pan Head
(SPS) screws are recommended for use with this product.
Micro-Pocket Drill Guide
Thank you for your purchase. For more information on Kreg products and to see a
complete list of Kreg Jig ® accessories, visit us online at www.kregtool.com.
Logo on white, gray
or any lighter shade
when printing color
Logo on Pantone
2945 or any darker
shade when printing
color
Logo on white
or light shade when
printing grayscale
Logo on black or
dark shade when
printing grayscale
Micro Pocket ™ Drill Guide Instructions
Item# KJmICRODGB Instructions
This Drill Guide is designed to work with both the Kreg Jig ® (K4) and Kreg Jig ®
Master System (K3). For the best possible performance, we recommend
that you use a genuine Kreg stepped drill bit to form the Pocket-Holes.
These Kreg products are made in the USA and are protected by one or more of the following U.S. Patents:
#4,955,766, #5,676,500, #6,481,937, #6,726,411. Other patent applications are pending or granted.
Working with ½” Material
When drilling Micro Pocket ™ Holes in ½” material the standard setting will leave your screw close
to the wood’s surface and without the ability to plug the Pocket-Hole. In order to create a ‘pluggable’
Micro Pocket ™ hole in ½” material, you’ll need to follow these simple steps to compensate:
• Set your Drill Guide for ½” material, as normal
• Set your Stop Collar for 5/8” material
• Replace standard 1” screws with the shorter ¾” version (SPS-F075)
19/64”
1-5/16”