Kreg PRS3038 Precision Router Table Insert Plate - Undrilled - Manual (Page 6)

Rabbeted opening method
1. Attach the router base to the insert plate, using the screws that
were used to attach the sub-base to the router base. Depending
on the thickness of your router sub-base, it may be necessary to
purchase longer screws. Make certain that the screws are long
enough to fully thread into the router base. For fi xed-base routers,
install the motor unit in the router base and install the insert plate,
with router attached, in the table.
2.
Drop the four lock-down screws through the countersunk holes in
the insert plate and thread them into the hex nut, wing nut or T-nut.
Tighten the screws.
Kreg Precision Router Table Insert Plate Levelers method
1.
With the table top upside down, position an insert-plate leveler
in one corner of the table-top opening, mating the curve on the
raised portion of the leveler with the radius corner of the opening.
Firmly holding the leveler in place and using the three mounting
holes in the leveler fl ange as guides, drill pilot holes into the table
top. Fasten the leveler to the tabletop with three 1¼" coarse-thread
screws provided [Drawing J]. Repeat with the remaining levelers.
Note: The 1¼" coarse-thread screws provided with the levelers
are for use on router table tops with a minimum thickness of 1". For
thinner tops, use your own shorter screws.
2.
Using the ⅛" hex wrench, drive a ¼-20 x 1½" socket-head set
screw into each outside hole in each leveler, threading them in
from the bottom until the tips are ⅜" below the table surface.
3.
For Kreg PRS3034 and PRS3036 Precision Insert Plates, fasten
the router base to the insert plate using the screws supplied with
the plate. For the Kreg PRS3038 Precision Insert Plate, use the
screws that were used to attach the sub-base to the router base
to attach the router base to the insert plate. Make certain that the
screws are long enough to fully thread into the router base. It may
be necessary to purchase longer screws. For fi xed-base routers,
install the motor unit in the router base.
Precision Insert Plate Installation
5.
Router table top
Mating Curves
Install the Insert Plate
J