Leprecon LPC Quick Start guide RevF - Manual (Page 21)

21
7. Chase
LPC uses Chase patterns to run sequences. Chases can be linked to cues or submasters, or
selected and controlled from a front panel fader.
The first four chases are permanent system chases, and cannot be altered. There are a total
of sixteen programmable chase patterns available.
7.1. Recording Chases
Select Record Chase to see the options for building a new chase. Data relating to the
specific chase is shown at the top of the screen, and channel data is shown below.
7.2. Chase properties
Each LPC chase has the following properties:
Pattern - specified which chase is being recorded.
Step - shows the last step saved
Title - A name that can be given to each chase pattern
Rate - the speed of the chase, shown in Beats Per Minute (BPM)
Loop Count - Setting a value for Loop Count will stop the chase after a specific number of