Leprecon LPC Quick Start guide RevF - Manual (Page 6)

6
The Settings screen sets the following conditions:
Manual mode -
This selects either 2 scene preset or wide mode for the manual faders. This change can
disrupt stage output, so is set as a configuration item.
Work Lamp intensity
This control sets the light level of the gooseneck work lamps.
3.3. Defaults
The Defaults area is used to set standard operating parameters for LPC.
This includes fade times and chase rate, and is applied to newly created items.
3.4. Clear
Clear functions are used to erase selected areas or the entire board memory.
3.5. Park
Board channels or specific DMX dimmer circuits can be set to a specific value for the
duration of a show or programming session. This is called ‘parking’. This can be useful
to turn on work lights, or turn off an improperly focused fixture.
Parked channels levels are not included in cues or submasters that are recorded while
the channels are on.
The interface for Park is shown below: