Leprecon LP-X24 Manual v3.2 Addendum - Manual (Page 34)

Setup Essentials Chapter Two 33
LP-X24 and LP-X48 Users Manual
There may be a slight delay as the LP-X opens the library.
Save Pan Tilt
#1 Cyberlight Cyberlight
Add New Instrument
Slot
1
DMX
101
The LP-X provides a default name for the instrument. You may use the keypad to
change the name.
The LP-X automatically assigns the instrument to an unassigned slot. Each slot
corresponds to a ML Select button in the Manual Scene section of the console.
On the LP-X24, Slots 1 through 12 correspond to ML Select buttons 1 through 12 in
bank 1. Slots 13 through 24 correspond to ML Select buttons 1 through 12 in bank
2. Slots 25 through 48 do not correspond to any ML Select buttons. They are
"virtual" slots, meaning that they exist in the computer's memory but do not have a
corresponding button on the hardware. Slots 25 through 48 are programmable
through the user interface, but not through the use of ML Select buttons.
On the LP-X48, Slots 1 through 24 correspond to ML Select buttons 1 through 24 in
bank 1. Slots 25 through 48 correspond to ML Select buttons 1 through 24 in bank
2. Slots 49 through 96 do not correspond to any ML Select buttons. They are
"virtual" slots, meaning that they exist in the computer's memory but do not have a
corresponding button on the hardware. Slots 49 through 96 are programmable
through the user interface, but not through the use of ML Select buttons.
Use the left wheel to change the slot to which the instrument is assigned.
The LP-X automatically assigns the instrument to the first available DMX channel.
Use the right wheel to change the DMX start address.
The LP-X48 automatically assigns the instrument to Line A, if it can accommodate
the fixture. Use the right wheel to change the line assignment.
6. You can invert the pan or tilt for the instrument by pressing the Pan or Tilt softkey.
Pressing either key a second time toggles the setting off.