Leprecon LP-X24 Manual v3.2 Addendum - Manual (Page 43)

42 Chapter Three Conventional Light Programming
LP-X24 and LP-X48 Users Manual—Addendum
effectively increases the number of playbacks from six to one hundred twenty or from
twelve to two hundred forty. To switch between pages, turn the Page Roller until the
desired page number appears on the Page Display.
During playback, when the Page Roller is moved to a new page, only the playbacks that
are at zero level will be loaded with new looks. Any fader that is not at zero will be in
“page hold” and will retain its current assignment until the fader is returned to zero. As
soon as the fader is moved to zero, the playback for the currently selected page is
automatically loaded.
Solo and Add “Bump” Buttons
In Run mode, the buttons beneath the six Playbacks and the twelve Manual Scene
Faders (LP-X24) or twelve Playbacks and twenty-four Manual Scene Faders function
as Solo or Add buttons
or are turned offdepending upon the Bump mode set for the
board.
Pressing and holding an Add button has the same effect as bringing up the fader. The
selected scene is added to the current look on stage. When you release the button, the
scene is removed from the look.
Pressing and holding a Solo button temporarily blacks out the rest of the console and
leaves only the selected scene up. Releasing the button restores normal operation.
Solo and Add buttons operate independently of the Master fader level.
Recording and Playing Back Conventional Light Looks
Before you begin, you must decide whether or not to use the default patch or to create a
custom patch of conventional lights to manual scene faders. Please see the section
"Dimmer Patch" beginning on page 37 for more information.
To Record Conventional Light Looks
1. Start by ensuring that all buttons and faders are in the proper positions.
Add, Solo or off