Leprecon LP-X24 Manual v3.2 Addendum - Manual (Page 42)

LP-X24 and LP-X48 Users Manual—Addendum
Chapter Three:
Conventional Light Programming
The following controls are the ones you will use when you operate the LP-X as a
conventional light console
that is, to operate non-moving light fixtures with intensity
only.
Bank Button
The LP-X24 provides twelve faders in the Manual Scene section of the board. The Bank
button effectively doubles the number of faders by permitting you to switch between
controlling faders 1 through 12 and faders 13 through 24.
The LP-X48 provides twenty-four faders in the Manual Scene section of the board. The
Bank button effectively doubles the number of faders by permitting you to switch
between controlling faders 1 through 24 and faders 25 through 48.
When you switch between banks, you may have to match and grab levels previously set
in order to control the fader's level again. For information about match and grab, please
see "Conventions Used in this Manual" beginning on page 12.
Page Roller
Although there are only six physical playbacks on the LP-X24 and twelve on the LP-X48,
the Page Roller selects any of twenty pages that will be active for a playback. This
Master Fader
Manual Scene Faders
Blackout
Playbacks
Manual Fader
Bank Button
Page Roller