Leprecon LP-X24 Manual v3.2 Addendum - Manual (Page 37)

36 Chapter Two Setup Essentials
LP-X24 and LP-X48 Users Manual—Addendum
This screen looks similar to the screen you see after you first add a moving light
instrument into the system.
Save Pan Tilt
#1 Cyberlight Cyberlight
Edit Instrument
Slot
1
DMX
101
4. Change the instrument name, DMX start address, or, on the LP-X48, DMX Line as
desired.
The slot assignment cannot be changed from this screen. Use the procedure
described in the section "Error! Reference source not found." beginning on page
Error! Bookmark not defined. to change the slot assignment.
5. Invert the pan or tilt as desired.
6. When you are done, press the Save softkey.
To Reserve and Un-reserve DMX Channels
By default, the LP-X reserves DMX channels 1 through 100 (LP-X24) or channels 1
through 200 (LP-X48) for conventional lights. You may prefer to reserve more, fewer or
different channels for conventional lights. Use this procedure to make such changes.
1. From the Setup Mode screen, press the Inst softkey.
The Instrument List screen appears.
Note that you can display the same screen when you press the DMX softkey from
the Setup Mode screen and then the Resrve softkey.
2. Press the Resrve softkey.