Leprecon LP-X24 Manual v3.2 Addendum - Manual (Page 48)

LP-X24 and LP-X48 Users Manual—Addendum
Chapter Four:
Moving Light Programming
In this chapter we introduce the subject of moving light programming and provide the key
information you will need to use the LP-X as a moving light programmer.
You will find additional information on advanced or specialized moving light
programming techniques in subsequent chapters.
Selecting Moving Lights for Programming using the Select Instruments
Screen
You use this selection technique when you are programming moving lights that have
been assigned to virtual slots
that is, moving lights that have been assigned to slots
that are higher than number 24 (LP-X24) or 48 (LP-X48).
1. In Record mode with the display set to ML, press the Fixture button.
The LP-X displays the Select Instruments screen. Instruments that are already
selected are highlighted.
Select Instruments
## [THRU ##] (+ -)
3 #1 Studio Color
4 #1 Technobeam
5 #2 Technobeam
6 #3 Technobeam
2 #1 Studio Spot Selected
Deselected
Out of Cue
Out of Cue
Out of Cue
Clear
2. To select one instrument, enter its number on the numeric keypad and then press
the Plus (+) key on the keypad.
3. To deselect one instrument, enter its number on the numeric keypad and then press
the Minus (-) key on the keypad.
4. To select a range of instruments, enter the lowest number in the range on the
numeric keypad, press the Thru key, enter the highest number in the range, and
then press the Plus (+) key on the keypad.