Marantz NR1403U - Manual (Page 96)

93
GM-XPortH
Symptom Cause/Solution Page
Audio is not output
when a wireless
receiver (RX101 is
connected). • Check that the Bluetooth device and Wireless receiver (RX101)
are correctly paired.
19 , 89 , 90
GRemote control unitH
Symptom Cause/Solution Page
The set cannot be
operated with the
remote control unit. • Batteries are worn out. Replace with new batteries.
• Operate the remote control unit within a distance of about
23 ft/7 m from this unit and at an angle of within 30°.
• Remove any obstacle between this unit and the remote control
unit.
• Insert the batteries in the proper direction, checking the q and
w marks.
• The set’s remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
83
83
83
83
83
Resetting the microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values.
X ON/STANDBY PRESET CH +
PRESET CH –
1
Turn off the power using X ON/STANDBY .
2
Press X ON/STANDBY while simultaneously pressing PRESET CH + and PRESET
CH – .
3 Once the display starts flashing at intervals of about 1 second, release the two
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mations
Inf
or
mations
DVD