Marantz NR1504 - Manual (Page 31)

28
Error messages
NOTE
• An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error message is displayed, check the relevant items and perform the
necessary measures. Then perform Audyssey® Setup again.
• If the result still differs from the actual connection status after re-measurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker
connections and repeat the measurement process from the beginning.
• Be sure to turn off the power before checking speaker connections.
Examples Error details Measures
Audyssey Setup
Caution!
Microphone or Speaker is none
Please check the cable connection
and retry.
Retry
• The connected Setup and measurement microphone is broken, or a device
other than the supplied Setup and measurement microphone is connected.
• Not all speakers could be detected.
• Connect the included Setup and measurement microphone to the SETUP
MIC jack of this unit.
• Check the speaker connections.
Audyssey Setup
Caution!
Ambient noise is too high or level is
too low
Retry
• There is too much noise in the room for accurate measurements to be
made.
• Speaker or subwoofer sound is too low for accurate measurements to be
made.
• Either turn off any device generating noise or move it away.
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction in which the speakers are
facing.
• Adjust the subwoofer’s volume.
Audyssey Setup
Caution!:Please check the cable connection
and retry.
Front R None
Retry
• The displayed speaker could not be detected.
(The screen on the left indicates that the front right speaker cannot be
detected.)
• Check the connections of the displayed speaker.
Audyssey Setup
Caution!:Please check the cable connection
and retry.
Front R Phase
Retry Phase Info. Skip
• The displayed speaker is connected with the polarity reversed.
(The screen on the left indicates that the polarity phases of the front right
speakers are reversed.)
• Check the polarity of the displayed speaker.
• For some speakers, this error message may be
displayed even if the speaker is properly connected.
If you are sure the connection is correct, use p to
select “Skip”, then press ENTER .
Set up speakers (Audyssey® Setup) Basic instructions
Advanced instructions
Information
Basic instructions
DVD