Marantz SR7005 - Manual (Page 57)

53
Basic version
Simple version
Information
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Advanced version
Front A/B connection
The second set of front speakers can be connected to the FRONT B/
HEIGHT terminals.
In this case, perform the settings using the SPKR A/B button on the
remote control or main unit (vpage 27 “Set the front speakers to be
used”).
FL(A) FL(B) FR(B) FR(A)
SW
For surround playback of a multichannel source, if you connect the
center speaker, surround speakers, surround back speakers (or front
wide speakers) and subwoofers, 7.1-channel playback is available.
Front speakers can be used separately, depending on the speaker’s
specifications or playback source such as front speakers (A) for
multichannel playback and front speakers (B) for 2-channel playback.
For speaker impedance and speaker cable connections, see page 5.
NOTE
When using the A front speakers and B front speakers simultaneously,
make sure you check the impedance of the connected speakers
(vpage 5).
2.1-channel connection
FL FR SW
n For connecting two subwoofers
Two subwoofers can be connected to this unit.
The same signal is output from each subwoofer terminal.
Connect
Bi-Amp connection
A bi-amp connection is to connect separate amplifiers to the tweeter
terminals and woofer terminals of speakers compatible with the
bi-amp function. This prevents the back electromotive force (returned
force without output) of the woofer sent to the tweeter, which affects
the sound quality of the tweeter, and you can enjoy playback with
higher-quality sound.
In this case, set “Set up “Amp Assign”” (vpage 54) to “SPKR-C”.
FL FR
w q w q
(R) (L)
When making a bi-amp connection, the same signal is output from the
FRONT terminal and the SURR.BACK/AMP ASSIGN terminal.
For surround playback of a multichannel source, if you connect the
center speaker, surround speakers and subwoofers, 5.1-channel
playback is available.
NOTE
• Use speakers compatible with bi-amp connections.
• When making bi-amp connections, be sure to remove the short-
circuiting plate or wire between the speaker’s woofer and tweeter
terminals.