Marantz SR7005 - Manual (Page 59)

55
Basic version
Simple version
Information
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Advanced version
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
8
G When “Surround Back” is selected
in step 6H
Use o p to select the item.
Measure
(2spkrs)
Set for measuring two surround back
speakers.
Measure
(1spkr)
Set for measuring a surround back
speaker.
Skip Set for no measuring of a surround
back speaker.
9
G When “Front Height” or “Front
Wide” is selected in step 6H
Use o p to select the item.
Measure Set to measure the front height
speakers or front wide speakers.
Skip Set when you do not want to measure
the front height speakers or front wide
speakers.
10
Press RETURN .
Proceed to page 9 STEP1 Preparation
step 5.
NOTE
After performing Audyssey® Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
Set up speakers Connections (Advanced connection)
REMOTE CONTROL jacks
When you use this unit connected to Marantz audio components, it sends operation signals to operate each component.
n Connection
Use the remote connection cable (supplied with a Marantz audio component you want to connect) to connect the REMOTE CONTROL OUT terminal of this
unit to the REMOTE CONTROL IN terminal of the component to be connected.
n Setting
Set the remote control switch located on the rear panel of the connected audio component to “EXTERNAL” or “EXT.” to use this feature.
• This setting will disable remote sensor reception of the connected audio component.
• To operate the connected audio component, point the remote control at the remote sensor of this unit.
EXTERNAL INTERNAL EXTERNAL INTERNAL EXTERNAL INTERNAL
REMOTE
CONTROL
OUT IN
REMOTE
CONTROL
OUT IN
REMOTE
CONTROL
OUT IN
CD recorder CD player DVD player
Remote control unit
Wireless receiver RX101 (vpage 23)
NOTE
To use wireless receiver RX101 as external IR
receiver, set the remote sensor function of this
unit to “Remote Lock:ON” (vpage 91 “Remote
control settings”).