Marantz UD9004 - Manual (Page 25)

Troubl
eshooting
Information
HDMI
Control
Function
Pl
ayback
Setup
Getting Started
Specifications
21
ENGLISH
Connecting to the Network
5. Updating to the UD9004’s Latest Software Version
You can update by downloading the latest firmware from the Internet. •
For more information, on the GUI menu, select “Other Setup” – “Firmware Update” (vpage 33).
See “Network Setup” (
• v page 31) on the GUI menu for more information on network setting.
Internet
Modem
Router
Computer
LAN port/
Ethernet
connector
To WAN port
To LAN port
To LAN port
NETWORK
connector
System Requirement
Internet Connection by Broadband Circuit n
Modem n
Device that connects to the broadband circuit and conducts communications on the Internet.
A type that is integrated with a router is also available.
Router n
When using the UD9004, we recommend a router with the following features.
Built-in DHCP (Dynamic Host Configuration Protocol) server. •
Function that automatically assigns an IP address on the LAN.
Built-in 100BASE-TX switch (built-in switching hub compatible with speeds upwards of 100 Mbps)
•
Ethernet cable (CAT-5 or greater recommended) n
An Ethernet cable is not included with the UD9004. •
For Ethernet cable, we recommend you use shielded straight cable (normal type). •
If you use the flat type or a non-shielded cable, the noise may adversely affect other devices.
For Internet connection, use an ISP (Internet Service Provider). Ask your local dealer for details.
NOTE
• It is necessary to subscribe to an ISP in order to connect to the Internet. If you already have a
broadband connection, there is no need to subscribe anew.
• The router you can use varies with the ISP. For more information, contact your ISP or PC dealer.
• MARANTZ assumes no responsibility whatsoever for any communication errors or troubles resulting
from customer's network environment or connected devices.
Others n
The UD9004 can use the DHCP function to automatically set the network. •
With the type of circuit in which network setting is performed manually, when subscribed to a provider, •
conduct the setting in accordance with “Network Setup” on the GUI menu (vpage 31).
If you connect the UD9004 to a network without a DHCP function, conduct IP address and other settings
•
according to “Network Setup” on the GUI menu (vpage 31).
The UD9004 does not support PPPoE. If you subscribe to a circuit that is set with PPPoE, a PPPoE-
•
compatible router is required.
When setting manually, check the setting contents with the network administrator.
•
Connections