Settings, Owired setup – Marantz NA6005 User Manual
Page 94
Settings
You can make detailed settings for the network.
To change the network environment, perform “Quick Setup”. (For details
on the operations, see the separate “Quick Start Guide”.)
0
If you are using a broadband router (DHCP function), there is no need to
make the settings at “IP Address” and “Proxy”, since the DHCP function
is set to “On” in this unit’s default settings.
0
Only set “Settings” when connecting to a network without a DHCP
function.
o
Wired Setup
n DHCP
Selects how to connect to the network.
On (Default): Configure the network settings automatically from your
router.
Off:
Configure the network settings manually.
n IP Address
Set the IP address within the ranges shown below.
0
The Network Audio function cannot be used if other IP addresses
are set.
CLASS A: 10.0.0.1 - 10.255.255.254
CLASS B: 172.16.0.1 - 172.31.255.254
CLASS C: 192.168.0.1 - 192.168.255.254
n Subnet Mask
When connecting an xDSL modem or connector adapter directly to
this unit, input the subnet mask indicated in the documentation
supplied by your provider. Normally input 255.255.255.0.
n Gateway
When connected to a gateway (router), input its IP address.
n Primary DNS, Secondary DNS
If there is only one DNS address indicated in the documentation
supplied by your provider, enter it for “Primary DNS”. If two or more
DNS are provided by your provider, enter one for “Secondary DNS”.
94