Marantz SA8005 - Manual (Page 51)

51
Appendix Tips Settings Connections Contents
Front panel Display Rear panel Index Remote
Playback
Connect and playback from a digital
device (Coaxial/Optical)
1 Connect digital device to this unit (vpage 20).
2 Press INPUT to select the playback media mode to
“Coaxial” or “Optical”.
The input digital audio signal is displayed as shown.
“Coax: xxxxk” or “Opt : xxxxk”
(xxxx is the sampling frequency.)
• If the sampling frequency cannot be detected, “Unlock” will be
displayed.
2 Files that can be played back
See “D/A converter” (vpage 70).
NOTE
• Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise
and could damage the speakers.
• If the sampling frequency switches, such as from A mode to B mode in a CS
broadcast, muting may operate for 1 – 2 seconds, cutting the sound.