Maytag WED4890BQ Installation - Manual (Page 7)

7
Electrical Connection
Power Supply Cord
Electrical Connection Options
1.
Choose electrical connection type
Power supply cord 4-wire receptacle
(NEMA Type 14-30R): Go to steps 1-2 on
page 8 for power supply cord strain relief;
then steps 3-6 for “4-wire Power Supply
Cord Connection” section. Then, go to
“Venting Requirements.”
3-wire direct connection: Go to steps
1-2 on page 10 for direct wire strain relief;
then steps 3-7 for “3-wire Direct Wire
Connection” section. Then go to “Venting
Requirements.”
4-wire direct connection: Go to steps
1-2 on page 10 for direct wire strain relief;
then steps 3-8 for “4-wire Direct Wire
Connection” section. Then go to “Venting
Requirements.”
Power supply cord 3-wire receptacle
(NEMA Type 10-30R): Go to steps 1-2 on
page 8 for power supply cord strain relief;
then steps 3-5 for “3-wire Power Supply
Cord Connection” section. Then go to
“Venting Requirements.”
NOTE: If local codes do not permit connection of a
cabinet-ground conductor to neutral wire, go to “Optional
3-wire Connection” section. This connection may be
used with either a power supply cord or a direct wire
connection.
1.
Prepare dryer for leveling legs
To avoid damaging floor, use a large flat piece of cardboard
from dryer carton; place under entire back edge of dryer.
Firmly grasp dryer body (not console panel) and gently lay
dryer down on cardboard.
2.
Screw in leveling legs
Using a wrench and tape measure, screw legs into leg
holes until bottom of foot is approximately 1/2" (13 mm)
(to match height of 3.6 cu. ft. capacity washer) or 1½"
(38 mm) (to match height of 3.8 cu. ft. capacity washer)
from bottom of dryer.
Now stand the dryer on its legs. Slide the dryer until it is
close to its final location. Leave enough room for electrical
connection and to connect the exhaust vent.
Install Leveling Legs