Power supply cord connection, Remove terminal block cover, Attach power supply cord to strain relief – Maytag WED4890BQ Installation User Manual

Page 8: Attach power supply cord strain relief

Advertising
background image

8

Direct Wire

A

B C

D

E

F

2.

Remove terminal block cover

Before you start, disconnect power. Remove hold-down screw

(D) and terminal block cover (A).

A. Terminal block cover

B. External ground conductor screw

C. Center terminal block screw

D. Hold-down screw

E. Neutral ground wire

F. Hole below terminal block cover

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the

strain relief. The strain relief should have a tight fit with the

dryer cabinet and be in a horizontal position. Do not further

tighten strain relief screws at this point.

For 3-wire Power Supply Cord Connection, see page 9.
For 4 wire Power Supply Cord Connection, continue to

step 3.

2.

Attach power supply cord

to strain relief

A

B

C

D

1.

Attach power supply cord

strain relief

Remove the screws from a 3/4" (19 mm) UL listed strain relief

(UL marking on strain relief). Put the tabs of the two clamp

sections (C) into the hole (B) below the terminal block opening

so that one tab is pointing up (A) and the other is pointing

down (D), and hold in place. Tighten strain relief screws just

enough to hold the two clamp sections (C) together.

Power supply cord strain relief

Power Supply Cord Connection

Advertising
This manual is related to the following products: