Measurement Computing WavePort rev.3.0 - Manual (Page 20)

3-2 System Setup 06-14-00 WavePort User’s Manual
Use the following technique to ensure proper alignment of the strips.
(1) Make two mounting strips that consist of mated Dual-Lock surfaces, such that the
outer surfaces of the strips are the “adhesive” sides of the strips. Note that these
adhesive edges are initially covered with protective “peel-off” paper.
(2) Trim the strips to fit the bottom surface of your Notebook PC, as needed.
(3) Remove the protective “peel-off” paper and attach the two strips to the bottom surface
of the Notebook PC.
(4) Remove the lower protective “peel-off” and position the Notebook PC onto
WavePort’s cover plate.