Denon ADV-1000 - Manual (Page 12)

12
ENGLISH
SPEAKER SYSTEMS
6 16 R L IMPEDANCE
CENTER
SURROUND
R L
FRONT
SUB
WOOFER
IN
V.AUX
OUT IN
TV/DBS
DIGITAL(OPTICAL)
IN OUT IN IN
TV/DBS
IN
V.AUX VCR
MON.OUT
S VIDEO
IN OUT IN IN
TV/DBS
IN
V.AUX VCR
MON.OUT
VIDEO
R
L
IN OUT IN IN IN OUT
V.AUX TV/DBS VCR CDR/
TAPE
PRE OUT
SUB WOOFER
AM
FM COAX. 75
LOOP ANT.
Y P B /C B
COMPONENT VIDEO OUT
P R /C R
AUDIO
COMPONENT VIDEO IN
P B /C B P R /C R Y
(5) Connecting to a TV or Monitor Equipped with Component Input Connectors.
• When making connections, also refer to the operating instructions of the other components.
• The video signals input to the VIDEO input (yellow) and S-Video input jacks are not output to the color difference (component) video jacks.
Connecting a monitor TV
MONITOR OUT jack
• Connect the TV’s color difference
(component) video input jacks
(COMPONENT VIDEO INPUT) to the
COMPONENT MONITOR OUT jack
using 75
Ω /ohms coaxial video pin-
plug cords.
Color component output connectors (P R /C R , P B /C B and Y)
The red (P R /C R ), blue (P B /C B ) and brightness (Y) signals are output independently, achieving more faithful
reproduction of the colors.
• The color component input connectors may be marked differently on some TVs or monitors (P R , P B and Y/R-
Y, B-Y and Y/C R , C B and Y, etc.). For details, refer to the TV’s operating instructions.
Connect in this way if your TV is compatible with Progressive Scan.
NOTES:
• Use the three commercially available video cords to connect the ADV-1000’s color component output connectors to the TV or
monitor.
• Set the “TV TYPE” in “VIDEO SETUP” in “DVD SETUP” to comply with your TV’s video format. When the TV is NTSC formated
set to NTSC.
• Set the “VIDEO OUT” in “VIDEO SETUP” in “SETUP” to comply with Progressive TV. (NTSC formated only)
CONSUMERS SHOULD NOTE THAT NOT ALL HIGH DEFINITION TELEVISION SETS ARE FULLY COMPATIBLE WITH THIS
PRODUCT AND MAY CAUSE ARTIFACTS TO BE DISPLAYED IN THE PICTURE. IN CASE OF 525 PROGRESSIVE SCAN PICTURE
PROBLEMS, IT IS RECOMMENDED THAT THE USER SWITCH THE CONNECTION TO THE “STANDARD DEFINITION” OUTPUT.