Denon ADV-1000 - Manual (Page 35)

35
3
1, 3 5
VOLUME
ENTER
BAND
MODE
MENU FUNCTION
DISPLAY RETURN INPUT MODE SURROUND
MUTE
SHIFT CH
TV/VCR SLEEP
CALL 0 +10
STATUS
VCR POWER
TV POWER TV POWER
NTSC/PAL
POWER
CH
1
3
5
2
12 OPERATION
Input mode setting
1 Either turn the FUNCTION/SELECT knob on the main unit or
press the FUNCTION button on the remote control unit to
select the input function to be played.
The presence or absence of digital signals is detected, the
signals input to the digital input are identified and decoding
and playback are performed automatically in DTS, Dolby
Digital or PCM (2 channel stereo) format.
If no digital signal (TV DBS and V.AUX) is being input, the
analog input jacks are selected.
Use this mode to play Dolby Digital signals.
w PCM (exclusive PCM signal playback mode)
Decoding and playback are only performed when PCM
signals are being input.
e DTS (exclusive DTS signal playback mode)
Decoding and playback are only performed when DTS
signals are being input.
r ANALOG (exclusive analog audio signal playback mode)
The signals input to the analog input jacks are played.
(This cannot be selected in the DVD mode.)
The input mode automatically switches to “AUTO” if you
switch the input function to DVD from anything other than
DVD.
FUNCTION
/ SELECT
FUNCTION
• The function switches as shown below.
• The function only changes in the “ Æ” direction when
operated from the remote control unit.
• The function switches as shown below.
• The function only changes in the “ Æ” direction when
operated from the remote control unit.
TUNER DVD
CDR/TAPE VCR
TV/DBS
V.AUX
2 When DVD, TV/DBS or V.AUX was selected as the input
function, press the remote control unit’s INPUT MODE
button to select the input mode.
Input mode selection function
• The input mode can be selected when the input function is
set to DVD, TV/DBS or V.AUX.
• Different input modes can be selected for each input
function. The selected input mode is stored in the memory
for the individual input functions.
• When the input function is set to something other than the
above, “ANALOG ONLY” is displayed and the input mode
cannot be selected.
q AUTO (auto mode)
In this mode, the type of signal being input to the digital
and analog input terminals is detected and the program in
the set’s surround decoder is switched automatically to
play the signals for the selected input function.
INPUT MODE
• “ANALOG” cannot be selected when DVD was selected as
the input function.
AUTO PCM DTS ANALOG
Main unit Remote control unit
Remote control unit
3 Either press the SURROUND MODE button on the main unit
then turn the FUNCTION/SELECT dial or press the
SURROUND button on the remote control unit to select the
surround mode.
SURROUND
MODE
STEREO
STEREO
AUTO DECODE 5CH STEREO MONO MOVIE
ROCK ARENA
DIRECT
JAZZ CLUB
VIRTUAL
VIDEO GAME
MATRIX ...
Main unit
FUNCTION
/ SELECT
Main unit
SURROUND
Remote control unit
ENGLISH
• The “AUTO DECODE” mode can be selected with the
AUTO DECODE button on the main unit, the “5CH
STEREO” mode with the 5CH STEREO button on the main
unit.