Denon ADV-1000 - Manual (Page 8)

8
ENGLISH
SPEAKER SYSTEMS
6 16 R L IMPEDANCE
CENTER
SURROUND
R L
FRONT
SUB
WOOFER
IN
V.AUX
OUT IN
TV/DBS
DIGITAL(OPTICAL)
IN OUT IN IN
TV/DBS
IN
V.AUX VCR
MON.OUT
S VIDEO
IN OUT IN IN
TV/DBS
IN
V.AUX VCR
MON.OUT
VIDEO
R
L
IN OUT IN IN IN OUT
V.AUX TV/DBS VCR CDR/
TAPE
PRE OUT
SUB WOOFER
AM
FM COAX. 75
LOOP ANT.
Y P B /C B
COMPONENT VIDEO OUT
P R /C R
AUDIO
OPTICAL
IN
OUTPUT
L R
INPUT
L R
L R
R L L R
L R
B
7 CONNECTIONS
• Do not plug in the AC cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left with
left, right with right).
• Insert the plugs securely. Incomplete connections will result in the
generation of noise.
• Note that binding pin plug cords together with AC cords or placing
them near a power transformer will result in generating hum or
other noise.
• Noise or humming may be generated if a connected audio
equipment is used independently without turning the power of this
unit on. If this happens, turn on the power of the this unit.
(1) Connecting the audio components
• When making connections, also refer to the operating instructions of the other components.
Subwoofer jack
Connect the internal amplifier’s subwoofer to the
subwoofer terminal.
• To conduct digital recording onto a digital recorder (CD recorder, MD
recorder, etc.) while playing Dolby Digital, 96 kHz PCM sources on
this DVD player.
• Set the “AUDIO SETUP” default setting as shown below. (See page
79, 80.)
• “DIGITAL OUT” → “PCM”
“LPCM SELECT” → “ON”
Playing DVDs with incorrect settings may result noise that could damage
your ears or the speakers.
AC CORD
AC 120 V, 60 Hz
Connecting a recorder
Connections for recording:
Connect the tape deck’s recording input jacks (LINE IN or REC) to this unit’s tape
recording (CDR/TAPE OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck’s playback output jacks (LINE OUT or PB) to this unit’s
tape playback (CDR/TAPE IN) jacks using pin plug cords.
CD recorder, MD recorder or Tape deck
Connecting the DIGITAL (optical) jacks
Use these for connections to audio equipment with digital (optical) output.
NOTES:
• Use optical cables for optical connections, removing the cap before connecting.
NOTES:
• Track numbers may not be added automatically when making digital
recordings of CDs being played on the ADV-1000 onto a connected
recorder.
• When making digital recordings on a CD recorder, set the CD
recorder’s recording setting to manual and add track numbers (track
marks) manually as you record.
• When making digital recordings on an MD recorder, use the editing
function after the recording is completed to divide the tracks.