Denon ADV-1000 - Manual (Page 36)

36
4 Start playback on the selected component.
• For operating instructions, refer to the component’s
manual.
• The volume can be adjusted within the range -60 to 0 to
+18 dB. Note that depending on the input signal, surround
mode, speaker settings and channel level setting, it may
not be possible to adjust the volume up to +18 dB.
5 Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume.
M.VOLUME -20
MASTER VOLUME
Main unit
VOLUME
Remote control unit
The volume level is displayed
on the display.
Input mode when playing DTS sources
• If DTS-compatible CDs are played in the “PCM” mode, noise is
output because DTS playback is not possible.
To play a DTS-compatible source, be sure to set the input mode
to “AUTO” or “DTS”.
• Noise may be generated at the beginning of playback and while
searching during DTS playback in the AUTO mode. If so, play in
the DTS mode.
• “DIG” lights when digital signals are input properly. If “DIG” is
flashing, check whether the connections are proper and whether
the input component’s power is on.
PRO LOGIC II
DIG PCM
DIGITAL
DTS
DIG PCM
DIGITAL
DTS
DIG PCM
DIGITAL
DTS
AUTO
ANA
DIG PCM DTS
ANA
DIG PCM AUTO DTS
ANA
DIG PCM AUTO DTS
ANA
DIG PCM AUTO DTS
Input mode display
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
One of these lights, depending on
the input signal.
Lit
Input signal display
• DOLBY DIGITAL
• DTS
• PCM
STATUS
Main unit
FUNCTION
/ SELECT
Main unit
STATUS
Remote control unit
2 To check the currently playing program source, etc.
Press the STATUS button.
ENGLISH
To perform this operation on the main unit, press the
STATUS button, then turn the FUNCTION/SELECT knob.
The current program source and surround settings are shown
on the display each time the button is pressed. (When the
function is set to DVD, the information is also displayed on the
TV screen.)
Input mode when playing CD sources
• When playing CDs containing recordings of live concerts, etc., in
the “AUTO” mode, the sound may be slightly broken at the
beginning. If this happens, switch to the “PCM” mode.
One of these
lights, depending
on the input
signal.