Denon ADV-1000 - Manual (Page 14)

14
ENGLISH
(7) Speaker system connections
• Use speaker cords with twisted wire cores and a diameter of 0.6 to
1.5 mm. Never use cords thicker than 1.5 mm or single-wire cords,
as they may damage the speaker terminals.
• Be sure to interconnect the polarities of the terminals on the
speakers and main unit ( ≈ to ≈, √ to √).
• When making connections, be careful that none of the core wires
of the speaker cords stick out and touch neighboring terminals,
other speaker cords or the rear panel.
• Speakers with an impedance of 6 to 16 Ω /ohms can be connected
for use as center and surround speakers.
Connection the speaker terminals
1. Push the lever. 2. Insert the cord. 3. Return the lever.
Connections
• When making connections, also refer to the operating instructions of the other components.
NOTE:
NEVER touch the speaker terminals when the power is on.
Doing so could result in electric shocks.
• The protector circuit may be activated if the set is played for long
periods of time at high volumes when speakers with an impedance
lower than the specified impedance are connected.
• Precautions when connecting speakers
If a speaker is placed near a TV or video monitor, the colors on
the screen may be disturbed by the speaker’s magnetism. If this
should happen, move the speaker away to a position where it
does not have this effect.
SPEAKER SYSTEMS
6 16 R L IMPEDANCE
CENTER
SURROUND
R L
FRONT
SUB
WOOFER
IN
V.AUX
OUT IN
TV/DBS
DIGITAL(OPTICAL)
IN OUT IN IN
TV/DBS
IN
V.AUX VCR
MON.OUT
S VIDEO
IN OUT IN IN
TV/DBS
IN
V.AUX VCR
MON.OUT
VIDEO
R
L
IN OUT IN IN IN OUT
V.AUX TV/DBS VCR CDR/
TAPE
PRE OUT
SUB WOOFER
AM
FM COAX. 75
LOOP ANT.
Y P B /C B
COMPONENT VIDEO OUT
P R /C R
AUDIO
(L) (R)
(L) (R)
FRONT SPEAKER
SYSTEMS
CENTER SPEAKER
SYSTEM
SURROUND
SPEAKER SYSTEMS
SUB WOOFER (NOTE)
Connector jack for
subwoofer with built-in
amplifier (super woofer),
etc.
Subwoofer without amplifier
(Super woofer)
NOTE: Subwoofer terminal
• When using a subwoofer not including a built-in amplifier,
connect to the “SUBWOOFER” speaker terminal.
• When using a subwoofer including a built-in amplifier, connect to
the “SUBWOOFER” PRE OUT terminal.