Microcom 470 - Manual (Page 46)

Designing Labels Using LDS Chapter 4
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
470 Operators Manual 38
4.5.6 FILLED OVAL
A filled oval field is broken down into five different parameters. The first two mark the
center point, the next two define the radius width (X) and height (Y). The fields to be
defaulted must be separated by commas and a carriage return must follow each field
definition.
The following is a list of filled oval field mnemonics and their default values:
XC, YC, RX, RY,TCI,,,,,,,, AN
1, 1, 1, 1, 18,,,,,,,, 0
Note: All values must be positive integers.
XC X CENTER COORDINATE
The X coordinate of the field is measured in dots. The far left edge of the label as
viewed from the front of the printer is X coordinate 1. There is no X coordinate 0. The X
coordinate increases in size from left to right (see Figure 7). An XB of 203 would place
the text one inch from the left side of the label.
YC Y CENTER COORDINATE
The Y coordinate of the field is measured in dots. A YB of one would be specified as
the first edge of the label coming out of the front of the printer during a label print. The
Y coordinate increases in size from the bottom to the top of the label (see Figure 7). A
YB of 203 would place text one inch from the bottom of the label.
RX RADIUS WIDTH
The width of the rectangle (measured in dots).
RY RADIUS HEIGHT
The height of the rectangle (measured in dots).
TCI TEXT CONVERSION IDENTIFIER
Always set to a value of 18.
AN ATTRIBUTE NUMBER
If this parameter is set to a value of 2, the field can be printed white on black. A value
of 0 is normal.