Nevion SDI-TD-3GMX-5 - Manual (Page 14)

HD-TD-3GMX-2 / HD-TD-3GDX-2 and SDI-TD-3GMX-5 / SDI-TD-3GDX-5 Rev. F
nevion.com | 14
will be!), but it is a fragile state, as it will immediately be replaced with one or more SDs as
soon they’re detected on inputs 3-5.
Input integrity 1…5: (Stored setting) The user can select which errors should be counted
and which can be ignored. The CCS and YCS count settings work as a pair, meaning that
both will either be counted or both will be ignored. If the user makes a change to one of
these bits, the module assumes that the new setting should be applied to both bits. The
web page will always be updated to show the actual setting. The CCRC and YCRC error
bits also work as a pair.
The available error bits are as follows:
EAV
– End of active video error
SAV – Start of active video error
LNUM – Line numbering error (HD only)
YCRC
– Luma CRC error (HD only)
CCRC – Chroma CRC error (HD only)
YCS – Luma checksum error
CCS – Chroma checksum error
LOCK
– Lock error
AP-CRC – Active picture CRC error (SD only)
FF-CRC – Full frame CRC error (SD only)
VS
– Video standard error
Inputs 3-5, which are SD only, will not have LNUM, YCRC or CCRC errors available, since
these only have meaning for HD.
Laser: (Stored setting) The only setting available for the laser is power On or Off. All other
settings should already be done at the factory.
The laser module is optional. Boards with factory mounted laser will have “-T” appended to
the module’s name, and only they will display the laser block in the graphical user interface.