Nevion PGM-HD-2x1-PB - Manual (Page 23)

PGM-HD-2x1-PB Rev. B
nevion.com | 23
misc 0 - NOT AVAILABLE BY
COMMAND.
ONLY FOUND in Conf
0 prog | fin
' ' | ovr Misc info
prog if the card is freshly programmed
by the bootloader and the program is still
un-finalized. fin is the normal condition.
ovr if DIP-switch 16 is set to the ON
position and the card is under DIP-switch
control.
Note 1: The info part of misc has
additional functionality when locate is
used: locating <remaining seconds>.
This enables a visible countdown clock
in Gyda, but is not a required part of
FLP400.
6.2 Normal control blocks
Block Blk
#
Commands Example Response Control
aprc 0-
17 lvl <gain> aprc 7 lvl -400 Audio processing
‘lvl’ means level and is the gain setting.
aprc 0 and 1 are related to input 1 and 2.
aprc 2-9 can be used to set gain for
individual channel pairs of input 1, while
aprc 10-17 can be used to set gain for
individual channel pairs for input 2.
ceq 0 - ceq 0 cd | ncd cable equalizer for electrical input 1. No
control, only used to report carry detect
or not carry detect.
ceq 1 - ceq 0 cd | ncd cable equalizer for electrical input 2. No
control, only used to report carry detect
or not carry detect.
cho 0-1 No commands available. Included to
show internal status and to update Gyda
graphics.
dly 0 <frames>frms dly 0 2frms 'tgt' <frames> frms Video delay
This sets the minimum video delay of the
card.
In info this block reports back the current
delay in nanoseconds. This will vary with
the incoming video standard.
dly 1-5 <frames>frms dly 3 4 frms 'tgt' <frames> frms Fade controls
dly 1: input 1 fade-in time
dly 2: input 2 fade-out time
dly 3: additional black frames
dly 4: input 2 fade-in time
dly 5: input 2 fade-out time
dly 6-7 <audio_samples>sps dly 6 30sps
dly 7 -960sps 'tgt' <audio_samples>
sps audio delay
The audio delay is given in audio
samples. Audio delay is always given
relative to video.
dly 8 <lines>lines
<samples>sps dly 8 1lines -30sps 'phase' <lines> lines
<samples> sps Video phase
If lines != 0 the resulting phase will vary
with incoming video standard, see dly 0
above.
gpi 0 act |
inact gpi 0 act
gpi 0 inact EDH generator
This gpi works as a simple 2:1 switch.
inact : EDH gen. off
act : EDH gen. on
mtx 0 <i1> <o1> ...<iN>
<oN>
<i1>
<o1>,<o2>,...<oN> mtx 0 0 2 1 4 5 5
mtx 0 0 0, 1 1, 2 2
mtx 0 0 0-9
size M:N i1 i2 i3... iN Audio matrix
mtx 0 (size 10:8) controls the audio
matrix; outputs 0-7 are embedded sound;
inputs 0-7 are de-embedded audio,