NIStune Type 2 V.1.6 - Manual (Page 15)

Type 2 Hardware Installation Manual Page 15 of 20
5. Y60 TB42E Patrol Installation
Please Refer to the Z32 300ZX Installation
Figure illustrates installation of installed 28 pin socket
Desolder the four pads next to the EPROM socket where marked 1 - 4
Where you have desoldered the four pads, solder in the supplied connector cable. The plastic
connector has a number '1' on it. This corresponds to pin 1 of the connector. Make sure that you
solder in the cable in the correct direction