NIStune Type 2 V.1.6 - Manual (Page 7)

Type 2 Hardware Installation Manual Page 7 of 20
Hot glue the corners of the board to the ECU and the connector plug. This ensures that the
board stays installed the EPROM socket and the connector does not come off when the ECU
in the vehicle endures vibration
If the board becomes dismounted or the ECU connector plug comes loose the ECU will enter limp
home mode.
Push all the components on the knock sensor board out of the way so they do not have
contact with the Nistune board.
Reinstall the knock sensor board, being wary of the knock sensor cable.