Rw-5 rewinder, Before installing the rewinder, Installing the rewinder – QuickLabel Kiaro! User Manual
Page 141: Chapter: 7
Kiaro! User Guide
125
7
RW-5 Rewinder
Before Installing the Rewinder
Before installing the rewinder, observe the following precautions.
•
No rewinder feet should float. The rewinder must be held level constantly.
•
The rewinder must be installed on the same plane as the printer.
•
When placing the rewinder on a desk, table, or other similar surface, it must be
sturdy and stable enough to support the weight of the printer and the rewinder.
•
Do not turn the rewinder mandrel by hand to rewind the media. Turning the
mandrel by hand can result in rewinder damage.
Installing the Rewinder
1
Ensure the power switch on the rewinder is in the off position.
2
Arrange the rewinder and brackets as illustrated below. Refer to this illustration
through the installation process.
R
R-U
U
RW-5