Uw-5 unwinder, Before installing the unwinder, Installing the unwinder – QuickLabel Kiaro! User Manual
Page 147: Chapter: 8
Kiaro! User Guide
131
8
UW-5 Unwinder
Before Installing the Unwinder
Before installing the unwinder, observe the following precautions.
•
No unwinder feet should float. The unwinder must be held level constantly.
•
The unwinder must be installed on the same plane as the printer.
•
When placing the unwinder on a desk, table, or other similar surface, it must be
sturdy and stable enough to support the weight of the printer and the unwinder.
•
Do not turn the unwinder mandrel by hand to unwind the media. Turning the
mandrel by hand can result in unwinder damage.
Installing the Unwinder
1
Ensure the power switch on the unwinder is in the off position.
2
Arrange the unwinder and brackets as illustrated below. Refer to this illustration
through the installation process.
3
Insert the tabs from bracket U into the slots on bracket R. These two brackets will
later be used to position the Kiaro! printer.
4
Fasten the R-U bracket to the U bracket using the supplied thumb nuts. Ensure the
threaded pin is centered in the adjustment slot.
R
R-U
U
UW-5