Dell X51 - Manual (Page 98)

98
Getting Connected
Using Cisco
®
LEAP Wireless LAN Security
Your Dell Axim X51/X51v supports 802.1x network authentication
between the client and server with a logon password using Cisco LEAP.
Cisco LEAP can be configured using the Odyssey Client application.
NOTE:
Before starting, ensure that the Wireless power is enabled using the
Wireless On/Off button.
NOTE:
LEAP is not supported on a peer-to-peer network. LEAP is not supported
on a low configuration Axim X51.
To start Odyssey Client:
1 Tap Start → Settings → Connections → Odyssey Client icon.
2 Tap Settings → Enable Odyssey.
To start using LEAP:
1 Obtain the following information from your network administrator:
• Network name
• Association mode
• Encryption method
2 From the Odyssey Client window, tap Settings → Configure → Add.
3 Enter the network name (SSID) if known, or tap Scan to search for
available Access Points. Tap Next.
4 LEAP will only support an infrastructure network, so do not change the
default settings in the drop-down menu. Tap Next.
5 Fill in the Association Mode and Encryption method. Tap Next.
6 EAP/TTLS is the default EAP type. Tap Add and select EAP/LEAP in
the window that opens up.
Unless you have an authentication certificate to use TTLS and have
configured your system to support it, remove EAP/TTLS.
NOTE:
Failure to remove EAP/TTLS when it is not properly set up may
prevent your wireless security system from functioning.
7 Tap Next.
8 Enter your user name and password. Tap Next.
9 Tap Finish to complete LEAP configuration.